Administrator Guide
Track 200 [up], Next-hop reachable (via Te 1/32)
,
Track 200 [up], Next-hop reachable (via Vl 20)
,
Track 200 [up], Next-hop reachable (via Po 5)
,
Track 200 [up], Next-hop reachable (via Po 7)
,
Track 200 [up], Next-hop reachable (via Te 2/18)
,
Track 200 [up], Next-hop reachable (via Te 2/19)
Use the show ip redirect-list (without the list name) to display all the redirect-lists configured on the device.
Dell#show ip redirect-list
IP redirect-list rcl0:
Defined as:
seq 5 permit ip 200.200.200.200
200.200.200.200 199.199.199.199 199.199.199.199
seq 10 redirect 1.1.1.2 tcp 234.224.234.234 255.234.234.234 222.222.222.222/24
seq 40 ack, Next-hop reachable (via Te 8/1), ARP resolved
Applied interfaces:
Te 8/0
NOTE: If, the redirect-list is applied to an interface, the output of show ip redirect-list redirect-list-name
command displays reachability and ARP status for the specified next-hop.
Showing CAM PBR Configuration Example :
Dell#show cam pbr stack-unit 1 port-set 0
TCP Flag: Bit 5 - URG, Bit 4 - ACK, Bit 3 - PSH, Bit 2 - RST, Bit 1 - SYN, Bit 0 -
FIN
Cam Port VlanID Proto Tcp Src Dst SrcIp DstIp Next-hop Egress
Index Flag Port Port MAC Port
-----------------------------------------------------------------------------------
------------------------------
06080 0 N/A IP 0x0 0 0 200.200.200.200
200.200.200.200 199.199.199.199
199.199.199.199 N/A NA
06081 0 N/A TCP 0x10 0 40 234.234.234.234 255.234.234.234
222.222.222.222/
24 00:00:00:00:00:09 8/1
Sample Configuration
The following configuration is an example for setting up a PBR. These are not comprehensive directions. They
are intended to give you a some guidance with typical configurations. You can copy and paste from these
examples to your CLI. Be sure you make the necessary changes to support your own IP Addresses, Interfaces,
Names, etc.
Graphic illustration of the configuration shown below:
The Redirect-List GOLD defined in this example, creates the following rules:
• description Route Gold traffic to the DS3.
• seq 5 redirect 10.99.99.254 ip 192.168.1.0/24 any “ Redirect to next-hop router IP 10.99.99.254 any
traffic originating in 192.168.1.0/24”
• seq 10 redirect 10.99.99.254 ip 192.168.2.0/24 any “ Redirect to next-hop router IP 10.99.99.254 any
traffic originating in 192.168.2.0/24”
Policy-based Routing (PBR) 679