Administrator Guide
LSPID LSP Seq Num LSP Checksum LSP Holdtime ATT/P/OL
B233.00-00 0x00000006 0xC38A 1124 0/0/0
eljefe.00-00 * 0x0000000D 0x51C6 1129 0/0/0
eljefe.01-00 * 0x00000001 0x68DF 1122 0/0/0
eljefe.02-00 * 0x00000001 0x2E7F 1113 0/0/0
Dell.00-00 0x00000004 0xCDA9 1107 0/0/0
Dell#
Controlling Routing Updates
To control the source of IS-IS route information, use the following command.
• Disable a specific interface from sending or receiving IS-IS routing information.
ROUTER ISIS mode
passive-interface interface
• For the Loopback interface on the RPM, enter the keyword loopback then a number from 0 to
16383.
• For a port channel, enter the keywords port-channel then a number from 1 to 255.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/ port
information.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Distribute Routes
Another method of controlling routing information is to filter the information through a prefix list.
Prefix lists are applied to incoming or outgoing routes and routes must meet the conditions of the prefix lists
or the Dell Networking OS does not install the route in the routing table. The prefix lists are globally applied
on all interfaces running IS-IS.
Configure the prefix list in PREFIX LIST mode prior to assigning it to the IS-IS process. For configuration
information on prefix lists, refer to Access Control Lists (ACLs).
Applying IPv4 Routes
To apply prefix lists to incoming or outgoing IPv4 routes, use the following commands.
NOTE
: These commands apply to IPv4 IS-IS only. To apply prefix lists to IPv6 routes, use ADDRESS-
FAMILY IPV6 mode, shown later.
• Apply a configured prefix list to all incoming IPv4 IS-IS routes.
ROUTER ISIS mode
distribute-list prefix-list-name in [interface]
• Enter the type of interface and slot/port information:
• For the Loopback interface on the RPM, enter the keyword loopback then a number from 0 to
16383.
• For a port channel, enter the keywords port-channel then a number from 1 to 255.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port
information.
Intermediate System to Intermediate System 511