Administrator Guide

• (OPTIONAL) To clear unknown source address (SA) drop counters when you configure the MAC
learning limit on the interface, enter the keywords learning-limit.
Example of the clear counters Command
When you enter this command, confirm that you want the Dell Networking OS to clear the interface counters
for that interface.
Dell#clear counters tengig 0/0
Clear counters on TenGigabitEthernet 0/0 [confirm]
Dell#
Enhanced Control of Remote Fault
Indication Processing
By default, MXL module processes RFI errors transmitted by remote peers and brings down the interface
when an RFI error is detected.
You must enter the interface configuration mode before configuring Remote Fault Indication (RFI).
You can use the following CLI commands to enable or disable processing of received RFI events:
Dell(conf-if-te-1/3)#remote-fault-signaling rx ?
on Enable
off Disable
The default is "remote-fault-signaling rx on".
Interfaces 445