Administrator Guide

View Advanced Interface Information
The following options have been implemented for the show [ip | running-config] interfaces
commands.
When you use the configured keyword, only interfaces that have non-default configurations display.
Example of show Commands that Use the configured Keyword
Example of the show interfaces switchport Command
The following example lists the possible show commands that have the configured keyword available:
Dell#show interfaces configured
Dell#show interfaces tengigabitEthernet 0 configured
Dell#show ip interface configured
Dell#show ip interface tengigabitEthernet 1 configured
Dell#show interfaces fortygigabitEthernet 0 configured
Dell#show ip interface fortygigabitEthernet 1 configured
Dell#show ip interface brief configured
Dell#show running-config interfaces configured
Dell#show running-config interface tengigabitEthernet 1 configured
In EXEC mode, the show interfaces switchport command displays only interfaces in Layer 2 mode and
their relevant configuration information. The show interfaces switchport command displays the
interface, whether it supports IEEE 802.1Q tagging or not, and the VLANs to which the interface belongs.
Dell#show interfaces switchport
Name: TenGigabitEthernet 13/0
802.1QTagged: True
Vlan membership:
Vlan 2
Name: TenGigabitEthernet 13/1
802.1QTagged: True
Vlan membership:
Vlan 2
Name: TenGigabitEthernet 13/2
802.1QTagged: True
Vlan membership:
Vlan 2
Name: TenGigabitEthernet 13/3
802.1QTagged: True
Vlan membership:
Vlan 2
--More--
Configuring the Interface Sampling Size
You can enter any value between five and 299 seconds (the default). If you enter 1 to 5 seconds, software
polling is done at 5 second intervals. If you enter 6 to 10 seconds, software polling is done at 10 second
interval. For any other value, software polling is done once every 15 seconds. So, for example, if you enter
“19”, you actually get a sample of the past 15 seconds.
All LAG members inherit the rate interval configuration from the LAG.
Interfaces 442