Administrator Guide

• View Basic Interface Information
• Configuring the Default Interface
• Enabling a Physical Interface
• Physical Interfaces
• Management Interfaces
• VLAN Interfaces
• Loopback Interfaces
• Null Interfaces
• VLAN Membership
• Port Channel Interfaces
• Load Balancing through Port Channels
• Changing the Hash Algorithm
• Server Ports
• Bulk Configuration
• Defining Interface Range Macros
• Monitoring and Maintaining Interfaces
• Splitting QSFP Ports to SFP+ Ports
• Configuring wavelength for 10–Gigabit SFP+ optics
• Converting a QSFP or QSFP+ Port to an SFP or SFP+ Port
• Layer 2 Flow Control Using Ethernet Pause Frames
• Configure MTU Size on an Interface
• Port-Pipes
• Auto-Negotiation on Ethernet Interfaces
• View Advanced Interface Information
• Enhanced Control of Remote Fault Indication Processing
Interface Types
The following table describes different interface types.
Table 23. Interface Types
Interface Type Modes Possible Default Mode Requires Creation Default State
Physical L2, L3 Unset No Shutdown (disabled)
Management N/A N/A No No Shutdown
(enabled)
Loopback L3 L3 Yes No Shutdown
(enabled)
Null N/A N/A No Enabled
Port Channel L2, L3 L3 Yes Shutdown (disabled)
Interfaces 401