Administrator Guide

Configuring FIP Snooping
FIP snooping is auto-configured on an Aggregator in standalone mode. You can display information on FIP
snooping operation and statistics by entering show commands. You can enable FIP snooping globally on all
FCoE VLANs on a switch or on an individual FCoE VLAN.
By default, FIP snooping is disabled.
To enable FCoE transit on the switch and configure the FCoE transit parameters on ports, follow these steps.
1 Enable the FCoE transit feature on a switch.
CONFIGURATION mode.
feature fip-snooping
2 Enable FIP snooping on all VLANs or on a specified VLAN.
CONFIGURATION mode or VLAN INTERFACE mode.
fip-snooping enable
By default, FIP snooping is disabled on all VLANs.
3 Configure the FC-MAP value used by FIP snooping on all VLANs.
CONFIGURATION VLAN or INTERFACE mode
fip-snooping fc-map fc-map-value
The default is 0x0EFC00.
The valid values are from 0EFC00 to 0EFCFF.
4 Enter interface configuration mode to configure the port for FIP snooping links.
CONFIGURATION mode
interface port-type slot/port
By default, a port is configured for bridge-to-ENode links.
5 Configure the port for bridge-to-FCF links.
INTERFACE or CONFIGURATION mode
fip-snooping port-mode fcf
NOTE: All these configurations are available only in PMUX mode.
NOTE: To disable the FIP snooping feature or FIP snooping on VLANs, use the no version of a command;
for example, no feature fip-snooping or no fip-snooping enable.
.
FIP Snooping 383