Administrator Guide

Important FRRP Points
FRRP provides a convergence time that can generally range between 150ms and 1500ms for Layer 2
networks.
The Master node originates a high-speed frame that circulates around the ring. This frame, appropriately, sets
up or breaks down the ring.
• The Master node transmits ring status check frames at specified intervals.
• You can run multiple physical rings on the same switch.
• One Master node per ring — all other nodes are Transit.
• Each node has two member interfaces — primary and secondary.
• There is no limit to the number of nodes on a ring.
• Master node ring port states — blocking, pre-forwarding, forwarding, and disabled.
• Transit node ring port states — blocking, pre-forwarding, forwarding, and disabled.
• STP disabled on ring interfaces.
• Master node secondary port is in blocking state during Normal operation.
• Ring health frames (RHF)
• Hello RHF: sent at 500ms (hello interval); Only the Master node transmits and processes these.
• Topology Change RHF: triggered updates; processed at all nodes.
Important FRRP Concepts
The following table lists some important FRRP concepts.
Concept Explanation
Ring ID Each ring has a unique 8-bit ring ID through which the ring is identified (for example,
FRRP 101 and FRRP 202.
Control VLAN Each ring has a unique Control VLAN through which tagged ring health frames (RHF)
are sent. Control VLANs are used only for sending RHF, and cannot be used for any
other purpose.
Member VLAN Each ring maintains a list of member VLANs. Member VLANs must be consistent across
the entire ring.
Port Role Each node has two ports for each ring: Primary and Secondary. The Master node
Primary port generates RHFs. The Master node Secondary port receives the RHFs. On
Transit nodes, there is no distinction between a Primary and Secondary interface when
operating in the Normal state.
Ring Interface
State
Each interface (port) that is part of the ring maintains one of four states”
• Blocking State — Accepts ring protocol packets but blocks data packets. LLDP,
FEFD, or other Layer 2 control packets are accepted. Only the Master node
Secondary port can enter this state.
• Pre-Forwarding State — A transition state before moving to the Forward state.
Control traffic is forwarded but data traffic is blocked. The Master node Secondary
Force10 Resilient Ring Protocol (FRRP) 363