Administrator Guide

feature fip-snooping
2 Enable FIP snooping on all VLANs or on a specified VLAN.
CONFIGURATION mode or VLAN INTERFACE mode.
fip-snooping enable
By default, FIP snooping is disabled on all VLANs.
3 Configure the FC-MAP value used by FIP snooping on all VLANs.
CONFIGURATION VLAN or INTERFACE mode
fip-snooping fc-map fc-map-value
The default is 0x0EFC00.
The valid values are from 0EFC00 to 0EFCFF.
4 Enter interface configuration mode to configure the port for FIP snooping links.
CONFIGURATION mode
interface port-type slot/port
By default, a port is configured for bridge-to-ENode links.
5 Configure the port for bridge-to-FCF links.
INTERFACE or CONFIGURATION mode
fip-snooping port-mode fcf
NOTE: To disable the FIP snooping feature or FIP snooping on VLANs, use the no version of a command;
for example, no feature fip-snooping or no fip-snooping enable.
.
Displaying FIP Snooping Information
Use the following show commands to display information on FIP snooping, .
Table 18. Displaying FIP Snooping Information
Command Output
show fip-snooping sessions [interface
vlan vlan-id]
Displays information on FIP-snooped sessions on all
VLANs or a specified VLAN, including the ENode
interface and MAC address, the FCF interface and
MAC address, VLAN ID, FCoE MAC address and FCoE
session ID number (FC-ID), worldwide node name
(WWNN) and the worldwide port name (WWPN).
show fip-snooping config
Displays the FIP snooping status and configured FC-
MAP values.
FCoE Transit 346