Administrator Guide

Dell(conf)#fc zone z1
Dell(conf-fc-zone-z1)#member al1
Dell(conf-fc-zone-z1)#exit
Creating Zonesets
A zoneset is a grouping or configuration of zones.
To create a zoneset and zones into the zoneset, use the following steps.
1 Create a zoneset.
CONFIGURATION mode
fc zoneset zoneset_name
2 Add zones into a zoneset.
ZONESET CONFIGURATION mode
member zonename
Example of Creating Zonesets
Dell(conf)#fc zoneset zs1
Dell(conf-fc-zoneset-zs1)#member z1
Dell(conf-fc-zoneset-zs1)#
Dell(conf-fc-zoneset-zs1)#exit
Dell(conf-fc-zoneset-zs1)#
Activating a Zoneset
Activating a zoneset makes the zones within it effective.
On a switch, only one zoneset can be active. Any changes in an activated zoneset do not take effect until it is
re-activated.
By default, the fcoe-map fabric map-namedoes not have any active zonesets.
1 Enter enter the fc-fabric command in fcoe-map to active or de-activate the zoneset.
Dell(conf-fcoe-map)#fc-fabric
Example:
Dell(conf)#fcoe-map map
Dell(conf-fcoe-map)#fc-fabric
Dell(conf-fmap-map-fcfabric)#active-zoneset set
Dell(conf-fmap-map-fcfabric)#no active-zoneset?
active-zoneset
Dell(conf-fmap-map-fcfabric)#no active-zoneset ?
<cr>
Dell(conf-fmap-map-fcfabric)#no active-zoneset
2 View the active zoneset.
show fc zoneset active
FC FPORT 333