Administrator Guide

5 0% ETS
6 0% ETS
7 0% ETS
Oper status is init
ETS DCBX Oper status is Down
Reason: Port Shutdown
State Machine Type is Asymmetric
Conf TLV Tx Status is enabled
Reco TLV Tx Status is enabled
0 Input Conf TLV Pkts, 0 Output Conf TLV Pkts, 0 Error Conf TLV Pkts
0 Input Reco TLV Pkts, 0 Output Reco TLV Pkts, 0 Error Reco TLV Pkts
The following table describes the show interface ets detail command fields.
Table 14. show interface ets detail Command Description
Field Description
Interface Interface type with stack-unit and port number.
Max Supported TC Group Maximum number of priority groups supported.
Number of Traffic Classes Number of 802.1p priorities currently configured.
Admin mode ETS mode: on or off.
When on, the scheduling and bandwidth allocation
configured in an ETS output policy or received in a
DCBx TLV from a peer can take effect on an
interface.
Admin Parameters ETS configuration on local port, including priority
groups, assigned dot1p priorities, and bandwidth
allocation.
Remote Parameters ETS configuration on remote peer port, including
Admin mode (enabled if a valid TLV was received or
disabled), priority groups, assigned dot1p priorities,
and bandwidth allocation. If the ETS Admin mode is
enabled on the remote port for DCBx exchange, the
Willing bit received in ETS TLVs from the remote peer
is included.
Local Parameters ETS configuration on local port, including Admin
mode (enabled when a valid TLV is received from a
peer), priority groups, assigned dot1p priorities, and
bandwidth allocation.
Operational status (local port) Port state for current operational ETS configuration:
• Init: Local ETS configuration parameters were
exchanged with peer.
• Recommend: Remote ETS configuration
parameters were received from peer.
Data Center Bridging (DCB) 304