Administrator Guide
Command Comments
stack-unit stack-number priority 1-14 Stacking specific. Stack config cloning is not
supported.
stack-unit stack-number stack-group <> Stacking specific. Stack config cloning is not
supported.
Stack-unit <> renumber <>
Restore factory defaults Action command, not present in xxxxx-config file.
Reset stack-unit Stacking specific
Power-cycle stack-unit <> Action command, not present in xxxxx-config file.
Global buffer profile
Cam-acl Not present in STOMP UI
Clonability Configuration apply command
Based on the status of check command on the target aggregator, you can proceed or abort the operation.
When the clonability check results in Failure, the clone config apply is automatically aborted. If clonability
check results in
Success, the Apply command proceeds further without any intervention. If the Check results
in Warnings, you are prompted to proceed or abort.
When the cloning configuration is getting committed, no new cloning checks are entertained until the target
aggregator device is up and running with the applied clone configuration. A log is generated once the target
aggregator is running completely with the cloned configuration.
Configuration Cloning 264