Administrator Guide

Implementation Information
In the Dell Networking OS, prefix lists are used in processing routes for routing protocols (for example, router
information protocol [RIP], open shortest path first [OSPF], and border gateway protocol [BGP]).
NOTE: Dell Networking OS does not support all protocols. It is important to know which protocol you are
supporting prior to implementing prefix lists.
Configuration Task List for Prefix Lists
To configure a prefix list, use commands in PREFIX LIST, ROUTER RIP, ROUTER OSPF, and ROUTER BGP
modes.
Create the prefix list in PREFIX LIST mode and assign that list to commands in ROUTER RIP, ROUTER OSPF
and ROUTER BGP modes.
The following list includes the configuration tasks for prefix lists, as described in the following sections.
• Configuring a prefix list
• Use a prefix list for route redistribution
For a complete listing of all commands related to prefix lists, refer to the Dell Networking OS Command Line
Interface Reference Guide.
Creating a Prefix List
To create a prefix list, use the following commands.
1 Create a prefix list and assign it a unique name.
You are in PREFIX LIST mode.
CONFIGURATION mode
ip prefix-list prefix-name
2 Create a prefix list with a sequence number and a deny or permit action.
CONFIG-NPREFIXL mode
seq sequence-number {deny | permit} ip-prefix [ge min-prefix-length] [le max-
prefix-length]
The optional parameters are:
• ge min-prefix-length: the minimum prefix length to match (from 0 to 32).
• le max-prefix-length: the maximum prefix length to match (from 0 to 32).
Access Control Lists (ACLs) 141