Administrator Guide

Determine the Order in which ACLs are
Used to Classify Traffic
When you link class-maps to queues using the service-queue command, the system matches the class-
maps according to queue priority (queue numbers closer to 0 have lower priorities).
As shown in the following example, class-map cmap2 is matched against ingress packets before cmap1.
ACLs acl1 and acl2 have overlapping rules because the address range 20.1.1.0/24 is within 20.0.0.0/8.
Therefore (without the keyword order), packets within the range 20.1.1.0/24 match positive against cmap1
and are buffered in queue 7, though you intended for these packets to match positive against cmap2 and be
buffered in queue 4.
In cases such as these, where class-maps with overlapping ACL rules are applied to different queues, use the
order keyword to specify the order in which you want to apply ACL rules. The order can range from 0 to
254. The Dell Networking OS writes to the CAM ACL rules with lower-order numbers (order numbers closer
to 0) before rules with higher-order numbers so that packets are matched as you intended. By default, all ACL
rules have an order of 255.
Example of the order Keyword to Determine ACL
Sequence
Dell(conf)#ip access-list standard acl1
Dell(config-std-nacl)#permit 20.0.0.0/8
Dell(config-std-nacl)#exit
Dell(conf)#ip access-list standard acl2
Dell(config-std-nacl)#permit 20.1.1.0/24 order 0
Dell(config-std-nacl)#exit
Dell(conf)#class-map match-all cmap1
Dell(conf-class-map)#match ip access-group acl1
Dell(conf-class-map)#exit
Dell(conf)#class-map match-all cmap2
Dell(conf-class-map)#match ip access-group acl2
Dell(conf-class-map)#exit
Dell(conf)#policy-map-input pmap
Dell(conf-policy-map-in)#service-queue 7 class-map cmap1
Dell(conf-policy-map-in)#service-queue 4 class-map cmap2
Dell(conf-policy-map-in)#exit
Dell(conf)#interface gig 1/0
Dell(conf-if-gi-1/0)#service-policy input pmap
Access Control Lists (ACLs) 129