Administrator Guide

Config-State Indicates whether the configured FCoE and FC parameters in the FCoE
map are valid: Active (all mandatory FCoE and FC parameters are correctly
configured) or Incomplete (either the FC-MAP value, fabric ID, or VLAN ID
are not correctly configured).
Oper-State Operational status of the link to the fabric: up (link is up and transmitting
FC traffic), down (link is down and not transmitting FC traffic), link-wait
(link is up and waiting for FLOGI to complete on peer FC port), or removed
(port has been shut down).
Members FN IOM with the FC Flex IO module Ethernet and FC ports, which are
members of the dedicated FCoE VLAN that carries storage traffic to the
specified fabric.
show qos dcb-map Command Examples
Dell# show qos dcb-map dcbmap2
State :Complete
PfcMode:ON
--------------------
PG:0 TSA:ETS BW:50 PFC:OFF
Priorities:0 1 2 4 5 6 7
PG:1 TSA:ETS BW:50 PFC:ON
Priorities:3
Table 93. show qos dcb-map Field Descriptions
Field Description
State Complete: All mandatory DCB parameters are correctly configured. In
progress: The DCB map configuration is not complete. Some mandatory
parameters are not configured.
PFC Mode PFC configuration in the DCB map: On (enabled) or Off.
PG Priority group configured in the DCB map.
TSA Transmission scheduling algorithm used in the DCB map: Enhanced
Transmission Selection (ETS).
BW Percentage of bandwidth allocated to the priority group.
PFC PFC setting for the priority group: On (enabled) or Off.
Priorities 802.1p priorities configured in the priority group.
show npiv devices brief Command Example
Dell# show npiv devices brief
Total NPIV Devices = 2
FC Flex IO Modules 1103