Administrator Guide

Dell(config-fcoe-name)# description "SAN_FABRIC_A"
Dell(config-fcoe-name)# fc-map 0efc00
Dell(config-fcoe-name)# keepalive
Dell(config-fcoe-name)# fcf-priority 128
Dell(config-fcoe-name)# fka-adv-period 8
5 Enable an upstream FC port:
Dell(config)# interface fibrechannel 0/0
Dell(config-if-fc-0)# no shutdown
6 Enable a downstream Ethernet port:
Dell(config)#interface tengigabitEthernet 0/0
Dell(conf-if-te-0)# no shutdown
Displaying NPIV Proxy Gateway Information
To display information on the NPG operation, use the show commands in the following table
Table 90. Displaying NPIV Proxy Gateway Information
Command Description
show interfaces status
Displays the operational status of Ethernet and Fibre Channel
interfaces on the FN IOM with the FC Flex IO module, NPG.
NOTE: Although the show interface status command
displays the Fiber Channel (FC) interfaces with the
abbreviated label of 'Fc' in the output, if you attempt to
specify a FC interface by using the interface fc
command in the CLI interface, an error message is
displayed. You must configure FC interfaces by using the
interface fi command in CONFIGURATION mode.
show fcoe-map [brief | map-name]
Displays the Fibre Channel and FCoE configuration parameters in
FCoE maps. Enter the brief keyword to display an overview of
currently configured FCoE maps.
Enter the name of an FCoE map to display the FC and FCoE
parameters configured in the map to be applied on FN IOM with
the FC Flex IO module Ethernet (FCoE) and FC ports.
show qos dcb-map
map-name
Displays configuration parameters in a specified DCB map.
show npiv devices [brief]
Displays information on FCoE and FC devices currently logged in
to the NPG.
FC Flex IO Modules 1100