Deployment Guide
Table Of Contents
- 1 Introduction
- 2 The Dell FX2 and FN I/O Modules
- 3 Initial out-of-box connectivity check and default settings
- 4 VLT and the example environments
- 5 FN IOM Dell Blade I/O manager and internal port mapping features
- 6 Environment One: Basic VLT deployment with VLT mode
- 7 Environment Two: Dell Networking switches with mVLT and IOM in Full Switch mode
- 8 Environment Three: Dell Networking switches with mVLT and FN IOM in programmable MUX mode.
- 9 Environment Four: VLT interoperability with Cisco vPC
- A References
- B Components
- C Terminology
- D Reset FN IOM to Default Factory Configuration
- E FN IOM initial out-of-box configuration and default settings
- F Support and feedback
47 PowerEdge FX2 – FN I/O Module – VLT Deployment Guide | Version 2.2
Example of show vlt brief on switch S4810-1.
S4810-1
S4810-1#show vlt brief
VLT Domain Brief
------------------
Domain ID: 2
Role: Primary
Role Priority: 1
ICL Link Status: Up
HeartBeat Status: Up
VLT Peer Status: Up
Local Unit Id: 0
Version: 6(2)
Local System MAC address: 00:01:e8:8b:32:48
Remote System MAC address: 00:01:e8:8b:34:d9
Remote system version: 6(2)
Delay-Restore timer: 90 seconds
Peer-Routing : Disabled
Peer-Routing-timeout timer: 0 seconds
Multicast peer-routing timeout: 150 seconds
Example of show vlt detail on switch S4810-1.
S4810-1
S4810-1#show vlt detail
Local LAG Id Peer LAG Id Local Status Peer Status Active
VLANs
------------ ----------- ------------ ----------- --------
-----
111 111 UP UP 1
123 124 UP UP 1