Deployment Guide
Table Of Contents
- 1 Introduction
- 2 The Dell FX2 and FN I/O Modules
- 3 Initial out-of-box connectivity check and default settings
- 4 VLT and the example environments
- 5 FN IOM Dell Blade I/O manager and internal port mapping features
- 6 Environment One: Basic VLT deployment with VLT mode
- 7 Environment Two: Dell Networking switches with mVLT and IOM in Full Switch mode
- 8 Environment Three: Dell Networking switches with mVLT and FN IOM in programmable MUX mode.
- 9 Environment Four: VLT interoperability with Cisco vPC
- A References
- B Components
- C Terminology
- D Reset FN IOM to Default Factory Configuration
- E FN IOM initial out-of-box configuration and default settings
- F Support and feedback
46 PowerEdge FX2 – FN I/O Module – VLT Deployment Guide | Version 2.2
Example of show mac-address-table on switch FN410S-A2.
FN410S-A2
FN410S-A2#show mac-address-table
Codes: *N - VLT Peer Synced MAC
VlanId Mac Address Type Interface
State
1 00:01:e8:8b:32:4a Dynamic Po 122
Active
1 00:01:e8:8b:34:db Dynamic Po 122
Active
1 00:18:8b:a2:cb:3b Dynamic Po 122
Active
1 18:a9:9b:d9:28:81 Dynamic (N) Po 101
Active
1 18:a9:9b:d9:28:84 Dynamic (N) Po 101
Active
1 18:a9:9b:d9:2f:27 Dynamic Po 104
Active
1 18:a9:9b:d9:2f:2a Dynamic Po 104
Active