Deployment Guide
Table Of Contents
- 1 Introduction
- 2 The Dell FX2 and FN I/O Modules
- 3 Initial out-of-box connectivity check and default settings
- 4 VLT and the example environments
- 5 FN IOM Dell Blade I/O manager and internal port mapping features
- 6 Environment One: Basic VLT deployment with VLT mode
- 7 Environment Two: Dell Networking switches with mVLT and IOM in Full Switch mode
- 8 Environment Three: Dell Networking switches with mVLT and FN IOM in programmable MUX mode.
- 9 Environment Four: VLT interoperability with Cisco vPC
- A References
- B Components
- C Terminology
- D Reset FN IOM to Default Factory Configuration
- E FN IOM initial out-of-box configuration and default settings
- F Support and feedback
16 PowerEdge FX2 – FN I/O Module – VLT Deployment Guide | Version 2.2
Module Overview section, but it can also be launched by typing the management IP address of the
FN IOM into a browser with a port number of 8081, i.e. 172.25.189.209:8081
The FX2 CMC I/O Module Overview page (Figure 12) is the preferred method to launch the FN IOM
Dell Blade I/O Manager GUI. When the Launch I/O Module GUI button is clicked the login page
(Figure 13) will allow authorized users access to this feature-rich application.
FX2 CMC I/O module overview