Concept Guide

LSP Interval: 33
GigabitEthernet 0/8 is up, line protocol is up
MTU 1497, Encapsulation SAP
Routing Protocol: IS-IS
Circuit Type: Level-1-2
Interface Index 38371358, Local circuit ID 2
Level-1 Metric: 10, Priority: 64, Circuit ID: systest-3.02
Hello Interval: 10, Hello Multiplier: 3, CSNP Interval: 10
Number of active level-1 adjacencies: 1
Level-2 Metric: 10, Priority: 64, Circuit ID: systest-3.02
Hello Interval: 10, Hello Multiplier: 3, CSNP Interval: 10
--More--
show isis neighbors
Display information about neighboring (adjacent) routers.
Syntax
show isis neighbors [level-1 | level-2] [detail] [interface]
Parameters
level-1 (OPTIONAL) Displays information about Level 1 IS-IS neighbors.
level-2 (OPTIONAL) Displays information about Level 2 IS-IS neighbors.
detail (OPTIONAL) Displays detailed information about neighbors.
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
•
For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Use this command to conrm that the neighbor adjacencies are operating correctly. If you suspect that they are
not, you can verify the specied area addresses of the routers by using the show isis neighbors command.
The following describes the show isis neighbors command shown in the following example.
Field Description
System Id The value that identies a system in an area.
Interface The interface, slot, and port in which the router was discovered.
State The value providing status about the adjacency state. The range is Up and Init.
Type This value displays the adjacency type (Layer 2, Layer 2 or both).
810 Intermediate System to Intermediate System (IS-IS)