Concept Guide

Version Description
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show ipv6 route command shown in the following examples.
Field Description
(undened) Identies the type of route:
• L = Local
• C = connected
• S = static
• R = RIP
• B = BGP
• IN = internal BGP
• EX = external BGP
• LO = Locally Originated
• O = OSPF
• IA = OSPF inter-area
• N1 = OSPF NSSA external type 1
• N2 = OSPF NSSA external type 2
• E1 = OSPF external type 1
• E2 = OSPF external type 2
• i = IS-IS
• L1 = IS-IS level-1
• L2 = IS-IS level-2
• IA = IS-IS inter-area
• * = candidate default
• > = non-active route
• + = summary routes
Destination
Identies the route’s destination IPv6 address.
Gateway Identies whether the route is directly connected and on which interface the route is
congured.
Dist/Metric Identies if the route has a specied distance or metric.
Last Change Identies when the route was last changed or congured.
Example
Dell#show ipv6 route
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
Gateway of last resort is not set
Destination Dist/Metric, Gateway, Last Change
-----------------------------------------------------
C 100::/64 [0/0]
Direct, Te 0/8, 20:00:18
C 400::/64 [0/0]
Direct, Tu 1, 00:09:02
S 800::/64 [1/0]
IPv6 Basics 675