Concept Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show ip route list test
Codes:C- connected, S - static, R - RIP,
B- BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O- OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2- OSPF NSSA external type 2, E1 - OSPF external type 1,
E2- OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2- IS-IS level-2, IA - IS-IS inter area, * - candidate default,
>- non-active route, + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
R 2.1.0.0/24 via 2.1.4.1, Te 4/4 120/2 3d0h
R 2.1.1.0/24 via 2.1.4.1, Te 4/4 120/2 3d1h
R 2.1.2.0/24 via 2.1.4.1, Te 4/4 120/1 3d0h
R 2.1.3.0/24 via 2.1.4.1, Te 4/4 120/1 3d1h
C 2.1.4.0/24 Direct, Te 4/4 0/0 3d1h
Related Commands
ip prex-list — enters CONFIGURATION-IP PREFIX-LIST mode and congures a prex list.
show ip prex-list summary — displays a summary of the congured prex lists.
show ip route summary
View a table summarizing the IP routes in the switch.
Syntax
show ip route summary
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show ip route summary shown in the following example.
Column Heading Description
Route Source Identies how the route is congured in the system.
Active Routes Identies the best route if a route is learned from two protocol sources.
Non-active Routes Identies the back-up routes when a route is learned by two dierent protocols. If the
best route or active route goes down, the non-active route becomes the best route.
638 IPv4 Routing