Concept Guide

show range
Display all interfaces congured using the interface range command.
Syntax
show range
Command Modes INTERFACE RANGE (cong-if-range)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf-if-range-te-0/6)#show range
interface tengigabitethernet 0/6
Dell(conf-if-range-te-0/6)#
Related Commands
interface — congures a physical interface on the switch.
show ip interface — displays Layer 3 information about the interfaces.
show interfaces — displays information on a specic physical interface or virtual interface.
shutdown
Disable an interface.
Syntax
shutdown
To activate an interface, use the no shutdown command.
Defaults The interface is disabled.
Command Modes INTERFACE
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
The shutdown command marks a physical interface as unavailable for trac. To discover if an interface is
disabled, use the show ip interface command. Disabled interfaces are listed as down.
Disabling a VLAN or a port channel causes dierent behavior. When a VLAN is disabled, the Layer 3 functions
within that VLAN are disabled. Layer 2 trac continues to ow. Entering the shutdown command on a port
channel disables all trac on the port channel and the individual interfaces within the port channel. To enable a
Interfaces 577