Concept Guide

Version Description
9.14(0.0) Introduced on the platforms S4048–ON, S6100–ON, Z9100–ON, S4048T-ON, S3048–
ON, S6000, S6010–ON, S5048F-ON, FN-IOM and MXL.
9.13(0.2P2) Introduced on the S3100.
Usage Information
This command has to be congured before the interface moves to Err-disabled state. If not, the recovery action is
not performed.
Related Commands errdisable recovery interval— Congure recovery timer interval for an interface.
errdisable recovery interval
Congure recovery time interval to move an interface from the Err-disabled state.
Syntax
errdisable recovery interval seconds
To remove the congured recovery time interval, use the no errdisable recovery interval seconds
command.
Parameters
interval seconds Enter the keyword interval and the number of seconds to recover the interface from
Err-disabled state. The range is from 30 to 86,400 seconds. The default is 300 seconds.
Defaults 300 seconds.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the platforms S4048–ON, S6100–ON, Z9100–ON, S4048T-ON, S3048–
ON, S6000, S6010–ON, S5048F-ON, FN-IOM, and MXL.
9.13(0.2P2) Introduced on the S3100.
Usage Information
Whenever the Err-disable recovery timer is recongured, it will get eective only after the current timer expires.
Following message is displayed after each Err-disable recovery timer conguration:
DellEMC(conf)# errdisable recovery interval 30
New timer interval will be effective from the next timer instance only.
Related Commands errdisable recovery cause — Enable automatic recovery of an interface from the error disabled state.
owcontrol
Controls how the system responds to and generates 802.3x pause frames on 10G and 40Gig stack units.
Syntax
flowcontrol rx {off | on} tx {off | on} pause-threshold value [monitor session-
ID]
542 Interfaces