Concept Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
hardware-address
For manual congurations, specify the client hardware address.
Syntax
hardware-address address
Parameters
address Enter the hardware address of the client.
Defaults none
Command Modes DHCP <POOL>
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
host-address
For manual (rather than automatic) congurations, assign a host to a single-address pool.
Syntax
host—address address
Parameters
address Enter the host IP address.
Defaults None
Command Modes DHCP-POOL
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14.1.3 This command replaces host command. Introduced on S3048–ON, S4048–ON,
S4048T-ON, S6000–ON, S6010–ON, S6100–ON, Z9100–ON, S3100, S6000, S4810,
S4820T, S5048F-ON, MXL, FN-IOM, and C9010.
Usage Information
When you upgrade the Dell EMC Networking OS from an earlier version to 9.14.1.3 or later, the system converts the
DHCP CONFIGURATION host command in the running conguration to the host-address command. If you
downgrade the Dell EMC Networking OS from version 9.14.1.3 or later to an earlier version, any existing host-
address
command is deleted from the running conguration. If you want to create manual DHCP bindings, use
the host command.
448 Dynamic Host Conguration Protocol