Concept Guide

Defaults Disabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information When you enable this command, if a Policy Map containing classication rules (ACL and/or dscp/ ip-precedence
rules) is applied to more than one physical interface on the same port pipe, only a single copy of the policy is
written (only one FP entry is used).
NOTE: An ACL itself may still require more that a single FP entry, regardless of the number of interfaces.
For more information, refer to the IP Access Control Lists , Prex Lists , and Route-map sections in the
Dell Networking Operating System Conguration Guide .
cam-threshold
Congure CAM threshold value for sending the syslog message on CAM usage. Congure silence period for stop receiving syslog message
on CAM usage.
Syntax
cam-threshold threshold {default | threshold-percent} silence-period {default |
silence-period-value}
NOTE:
This command is applicable only in Full-Switch mode.
Defaults
Enabled
Parameters
threshold default
Enter the keyword default for CAM usage threshold for notication of the CAM usage
through syslog message. The default threshold value is 90 percent.
threshold
threshold-percent
Enter the threshold percent for notication of the CAM usage through syslog message.
The range is from 1 to 100 percent.
silence-period
default
Enter the keyword default to set the silence period for receiving syslog message
regarding CAM usage for CAM region, slot/portpipe. The default silence period is 0
seconds.
silence-period
silence-period-value
Enter the silence period for stop receiving syslog message for the respective CAM region,
slot/portpipe. The range is from 0 to 65535 seconds.
Command Modes CONFIGURATION
Supported Modes Full-Switch
382 Content Addressable Memory (CAM)