Concept Guide

Defaults Not enabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information At least one interface must be in Layer 3 mode for the router bgp command to be accepted. If no interfaces
are enabled for Layer 3, an error message appears:
% Error: No router id
configured
Example
Dell(conf)#router bgp 3
Dell(conf-router_bgp)#
shutdown all
Disables all the BGP neighbors.
Syntax
shutdown all
Use the no shutdown all command to enable all the congured BGP neighbors.
Command Modes ROUTER BGP
Command History
Version Description
9.11.0.0 Introduced on the S-Series, Z-Series, MXL, and IOM.
Usage Information
You can use this command to disable all the congured BGP neighbors.
This command is global for all VRFs.
shutdown address-family-ipv4–multicast
Disables all the BGP neighbors corresponding to the multicast IPv4 address families.
Syntax
shutdown address-family-ipv4–unicast
Use the no shutdown address-family-ipv4–unicast command to enable all the congured BGP
neighbors corresponding to the multicast IPv4 address families.
Command Modes
ROUTER BGP
CONFIGURATION
Command History
Version Description
Border Gateway Protocol IPv4 (BGPv4) 337