Concept Guide

DellEMC(conf)#no service timestamps log
DellEMC# show command-history
[May 17 15:53:44]: CMD-(CLI):[show logging]by default from console
[May 17 15:53:53]: CMD-(CLI):[show command-history]by default from console
[May 17 15:54:54]: CMD-(CLI):[end]by default from console
[May 17 15:55:00]: CMD-(CLI):[show logging]by default from console
[May 17 15:55:12]: CMD-(CLI):[show clock]by default from console
[May 17 15:55:22]: CMD-(CLI):[show running-config]by default from console
[May 17 15:55:27]: CMD-(CLI):[show command-history]by default from console
Related Commands clear command history — clears the command history log.
show conguration lock
Display the conguration lock status.
Syntax
show configuration lock
Defaults None
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information The type may be auto, manual, or rollback. When set to auto, Dell Networking OS automatically denies access to
CONFIGURATION mode to all other users every time the user on the listed VTY line enters CONFIGURATION
mode. When set to manual, the user on the listed VTY line must explicitly set the lock each time before entering
CONFIGURATION mode. Rollback indicates that Dell Networking OS is in a rollback process. The line number
shown in the output can be used to send the messages to that session or release a lock on a VTY line.
Example
Dell#show configuration lock
Configure exclusively locked by the following line:
Line : vty 0
Line number : 2
User : admin
Type : AUTO
State : LOCKED
Ip address : 10.11.9.97
Dell#
show cpu-trac-stats
Display the CPU trac statistics.
Syntax
show cpu-traffic-stats [port number | all]
Parameters
port number (OPTIONAL) Enter the port number to display trac statistics on that port only. The
range is from 1 to 1568.
Control and Monitoring 111