CLI Guide

• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent eld
operator (OPTIONAL) For the TCP and UDP parameters only. Enter one of the following logical
operand:
• eq = equal to
• neq = not equal to
•
gt = greater than
• lt= less than
• range = inclusive range of ports (you must specify two ports for the port command
parameter.)
source port Enter the keywords source-port then the port number to be matched in the ACL rule
in the ICAP rule
destination-port Enter the keywords destination-port then the port number to be matched in the
ACL rule in the ICAP rule.
source-port-range Enter the keywords Source-port-range then the range of the start port to end port
to be matched in the ACL rule in the ICAP rule.
destination-port-
range
Enter the keywords destination-port-range then the range of the start port to
end port to be matched in the ACL rule in the ICAP rule.
Defaults none
Command Modes REDIRECT-LIST
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Added support for thetrack-id on the MXL.
9.4(0.0) Added support for removing the Sonet interface on the MXL 10/40GbE Switch IO
Module.
show cam pbr
Displaysthe PBR CAM content.
Syntax
show cam pbr {[interface interface] | stack—unit slot-number port-set number]}
[summary]
Parameters
interface interface Enter the keyword interface then the name of the interface.
stack–unit number Enter the keyword stack-unit then the slot number. The range is from 0 to 11 .
port-set number Enter the keywords port-set then the port-pipe number. The range is from 0 to 0.
summary Enter the keyword summary to view only the total number of CAM entries.
Policy-based Routing (PBR) 987