CLI Guide

ip redirect-group
Apply a redirect list (policy-based routing) on an interface. You can apply multiple redirect lists to an interface by entering this command
multiple times.
Syntax
ip redirect-group redirect-list-name
To remove a redirect list from an interface, use the no ip redirect-group name command.
Parameters
redirect-list-name Enter the name of a congured redirect list.
Defaults none
Command Modes INTERFACE (conf-if-vl-)
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series TeraScale.
7.4.2.0 Added support for LAG and VLAN interfaces.
7.7.1.0 Introduced on the E-Series ExaScale.
Usage Information
You can apply any number of redirect-groups to an interface. A redirect list can contain any number of congured
rules. These rules includes the next-hop IP address where the incoming trac is to be redirected.
If the next hop address is reachable, trac is forwarded to the specied next hop. Otherwise, the normal routing
table is used to forward trac. When a redirect-group is applied to an interface and the next-hop is reachable, the
rules are added into the PBR CAM region. When incoming trac hits an entry in the CAM, the trac is redirected
to the corresponding next-hop IP address specied in the rule.
NOTE: Apply the redirect list to physical, VLAN, or LAG interfaces only.
Related Commands
show cam pbr – displays the content of the PBR CAM.
show ip redirect-list – displays the redirect-list conguration.
ip redirect-list
Congure a redirect list and enter REDIRECT-LIST mode.
Syntax
ip redirect-list redirect-list-name
To remove a redirect list, use the no ip redirect-list command.
982 Policy-based Routing (PBR)