CLI Guide

Policy-based Routing (PBR)
Policy-based routing (PBR) allows you to apply routing policies to specic interfaces. To enable PBR, create a redirect list and apply it to the
interface. After the redirect list is applied to the interface, all trac passing through the interface is subject to the rules dened in the
redirect list. PBR is supported by the Dell Networking operating software (OS).
You can apply PBR to physical interfaces and logical interfaces (such as a link aggregation group [LAG] or virtual local area network
[VLAN]). Trace lists and redirect lists do not function correctly when you congure both in the same conguration.
NOTE: Apply PBR to Layer 3 interfaces only.
Topics:
• description
• ip redirect-group
• ip redirect-list
• permit
• redirect
• seq
• show cam pbr
• show ip redirect-list
description
Add a description to this redirect list.
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
description Enter a description to identify the IP redirect list (16 characters maximum).
Defaults none
Command Modes REDIRECT-LIST
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands ip redirect-list – enables an IP Redirect List.
43
Policy-based Routing (PBR) 981