CLI Guide

Version Description
9.2(0.0) Introduced on the M I/O Aggregator.
Usage Information
The show crypto ipsec sa ipv6 command output displays security associations set up for OSPFv3 links in
IPsec authentication and encryption policies on the router.
show ipv6 ospf interface
View OSPFv3 interface information.
Syntax
show ipv6 ospf [interface]
Parameters
interface
(OPTIONAL) Enter one of the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet and
the slot/port information.
• For a Port Channel interface, enter the keywords port-channel and a number. The
range is from 1 to 128.
•
For a Tunnel interface, enter the keywords tunnel and a number. The range is from 1
to 16383.
• For a VLAN, enter the keyword vlan and a number from 1 to 4094.
Defaults none
Command Modes
EXEC
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
Usage Information
If you enable BFD at the global level, show ipv6 ospf interface shows the BFD provisioning.
If you enable BFD at the interface level, show ipv6 ospf interface shows the BFD interval timers.
Example
Dell#show ipv6 ospf interface Tengigabitethernet 1/0
TenGigabitEthernet 1/0 is up, line protocol is up
Link Local Address fe80::201:e8ff:fe17:5bbd, Interface ID 67420217
Area 0, Process ID 1, Instance ID 0, Router ID 11.1.1.1
NetworkType BROADCAST, Cost: 1, Passive: No
Transmit Delay is 100 sec, State DR, Priority 1
Interface is using OSPF global mode BFD configuration.
Designated router on this network is 11.1.1.1 (local)
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 1, Retransmit 5
Dell#
978 Open Shortest Path First (OSPFv2 and OSPFv3)