CLI Guide

• debug ipv6 ospf
• debug ipv6 ospf spf
• default-information originate
• graceful-restart grace-period
• graceful-restart mode
• ipv6 ospf area
• ipv6 ospf authentication
• ipv6 ospf bfd all-neighbors
• ipv6 ospf cost
• ipv6 ospf dead-interval
• ipv6 ospf encryption
• ipv6 ospf graceful-restart helper-reject
• ipv6 ospf hello-interval
• ipv6 ospf priority
• ipv6 router ospf
• maximum-paths
• passive-interface
• redistribute
• router-id
• show crypto ipsec policy
• show crypto ipsec sa ipv6
• show ipv6 ospf database
• show ipv6 ospf interface
• show ipv6 ospf neighbor
• timers spf
OSPFv2 Commands
The Dell Networking implementation of OSPFv2 is based on IETF RFC 2328.
area default-cost
Set the metric for the summary default route the area border router (ABR) generates into the stub area. Use this command on the border
routers at the edge of a stub area.
Syntax
area area-id default-cost cost
To return default values, use the no area area-id default-cost command.
Parameters
area-id Specify the OSPF area in dotted decimal format (A.B.C.D.) or enter a number from zero
(0) to 65535.
cost Species the stub area’s advertised external route metric. The range is from zero (0) to
65535.
Defaults cost = 1; no areas are congured.
Command Modes ROUTER OSPF
Supported Modes Full—Switch
906 Open Shortest Path First (OSPFv2 and OSPFv3)