CLI Guide

fcf-priority
In an FCoE map, congure the priority used by a server CNA to select an upstream FCoE forwarder (FCF).
Syntax
fcf—priority priority
Parameters
priority Enter the priority assigned to the FN 2210S Aggregator NPIV proxy gateway, which
appears to a downstream server CNA as an FCF. The range of FCF priority values is from
1 to 255.
Defaults 128
Command Modes FCOE MAP
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.6(0.0) Supported on the FN 2210S Aggregator.
9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO
module.
Usage Information
The FCF priority you assign to an FN 2210S Aggregator is used by server CNAs to select an upstream FCF to use
for a fabric login (FLOGI).
To remove a congured FCF priority from an FCoE map, enter the no fcf-priority command.
Related Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication between servers
and a SAN fabric.
show fcoe-map displays the Fibre Channel and FCoE conguration parameters in FCoE maps.
fc-map
In an FCoE map, congure the FCoE mapped address prex (FC-MAP) value which is used to identify FCoE trac transmitted on the
FCoE VLAN for the specied fabric.
Syntax
fc—map fc-map-value
Parameters
fc-map-value Enter the unique MAC address prex used by a SAN fabric.
The range of FC-MAP values is from 0EFC00 to 0EFCFF.
Defaults None
Command Modes FCoE MAP
Supported Modes Programmable-Mux (PMUX)
892 NPIV Proxy Gateway