CLI Guide
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Supported on the M I/O Aggregator.
Usage Information
A DCB map is a template used to congure DCB parameters and apply them on converged Ethernet interfaces.
DCB parameters include priority-based ow control (PFC) and enhanced trac selection (ETS).
To display the PFC and ETS settings in DCB maps, enter the show qos dcb-map command.
Use the dcb-map command to create a DCB map to specify PFC and ETS settings and apply it on Ethernet ports.
After you apply a DCB map to an interface, the PFC and ETS settings in the map are applied when the Ethernet
port is enabled. DCBx is enabled on Ethernet ports by default.
The dcb-map command is supported only on physical Ethernet interfaces.
To remove a DCB map from an interface, enter the no dcb-map map-name command in Interface conguration
mode.
Related Commands
show qos dcb-map– displays the dcb-map proles congured on the system.
dcb-map stack-unit all stack-ports all– applies a DCB map on all ports of a switch stack.
description (for FCoE maps)
In an FCoE map, add a text description of the FCoE and FC parameters used to transmit storage trac over an FN 2210S Aggregator and
M I/O Aggregator NPIV proxy gateway in a converged fabric.
Syntax
description text
Parameters
text Enter a maximum of 32 characters.
Defaults None
Command Modes FCOE MAP
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.6(0.0) Supported on the FN 2210S Aggregator.
9.3(0.0) Supported on the M I/O Aggregator.
Usage Information
The text description is displayed in show fcoe-map command output.
890 NPIV Proxy Gateway