CLI Guide

Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
clear lldp neighbors
Clear LLDP neighbor information for all interfaces or a specic interface.
Syntax
clear lldp neighbors {interface}
Parameters
interface Enter the following keywords and slot/port or number information:
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
Defaults none
Command Modes EXEC Privilege
Supported Modes
Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
debug lldp interface
Enable LLDP debugging to display timer events, neighbor additions or deletions, and other information about incoming and outgoing
packets.
Syntax
debug lldp interface {interface | all}{events | packet {brief | detail} {tx |
rx | both}}
To disable debugging, use the no debug lldp interface {interface | all}{events} {packet
{brief | detail} {tx | rx | both}} command.
Parameters
interface Enter the following keywords and slot/port or number information:
For a 10-Gigabit Ethernet interface, enter the keyword tenGigabitEthernet
followed by the slot/port information.
all (OPTIONAL) Enter the keyword all to display information on all interfaces.
events (OPTIONAL) Enter the keyword events to display major events such as timer events.
836 Link Layer Discovery Protocol (LLDP)