CLI Guide

Parameters
port-protocol-vlan-
id
Enter the keywords port-protocol-vlan-id to advertise the port protocol VLAN
identication TLV.
port-vlan-id Enter the keywords port-vlan-id to advertise the port VLAN identication TLV.
vlan-name Enter the keywords vlan-name to advertise the vlan-name TLV.
Defaults Disabled.
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands
protocol lldp (Conguration) — enables LLDP globally.
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
show running-cong lldp — displays the LLDP running conguration.
advertise dot3-tlv
Advertise dot3 TLVs (Type, Length, Value).
Syntax
advertise dot3-tlv {max-frame-size}
To remove advertised dot3-tlv, use the no advertise dot3-tlv {max-frame-size} command.
Parameters
max-frame-size Enter the keywords max-frame-size to advertise the dot3 maximum frame size.
Defaults none
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Supported Modes
Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
834 Link Layer Discovery Protocol (LLDP)