CLI Guide

If the track ip command is not congured, the VLAN's Layer 3 operational state depends on all the members of
the VLAN.
The Layer 2 state of the VLAN, and hence the Layer 2 trac, is not aected by the track ip command
conguration.
Related Commands
interface vlan — congures a VLAN.
tagged — species which interfaces in a VLAN are tagged.
untagged
Add a Layer 2 interface to a VLAN as an untagged interface.
Syntax
untagged interface
To remove an untagged interface from a VLAN, use the no untagged interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
Defaults All interfaces in Layer 2 mode are untagged.
Command Modes INTERFACE VLAN
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Untagged interfaces can only belong to one VLAN.
In the Default VLAN, you cannot use the no untagged interface command. To remove an untagged
interface from all VLANs, including the Default VLAN, enter INTERFACE mode and use the no switchport
command.
Related Commands
interface vlan — congures a VLAN.
tagged — species which interfaces in a VLAN are tagged.
832 Layer 2