CLI Guide

ftp After entering the keyword ftp you can either follow it with the location of the source le
in this form://userid:password@hostip/filepath, or press Enter to launch a
prompt sequence.
scp After entering the keyword scp you can either follow it with the location of the source le
in this form://userid:password@hostip/filepath, or press Enter to launch a
prompt sequence.
tftp After entering the keyword tftp you can either follow it with the location of the source
le in this form://hostlocation/filepath, or press Enter to launch a prompt
sequence.
ash After entering the keyword flash you can either follow it with the location of the source
le in this form://filepath, or press Enter to launch a prompt sequence.
usbash After entering the keyword usbflash you can either follow it with the location of the
source le in this form://filepath, or press Enter to launch a prompt sequence.
A: Enter this keyword to upgrade the bootash partition A.
B: Enter this keyword to upgrade the bootash partition B.
Defaults none
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information You must reload Dell Networking OS after executing this command. Use the command upgrade system
stack-unit to copy Dell Networking OS from the management unit to one or more stack members.
Example
Dell#upgrade system ?
flash: Copy from flash file system (flash://filepath)
ftp: Copy from remote file system, IPv4 or IPv6, (ftp:/
/userid:password@hostip/filepath)
scp: Copy from remote file system, IPv4 or IPv6, (scp:/
/userid:password@hostip/filepath)
stack-unit Sync image to the stack-unit
tftp: Copy from remote file system, IPv4 or IPv6, (tftp:/
/hostip/filepath)
usbflash: Copy from usbflash file system (usbflash://
filepath)
Dell#
verify
Validate the software image on the ash drive after the image has been transferred to the system, but before the image has been installed.
Syntax
verify { md5 | sha256 }[ flash:// ] img-file [hash-value]
Parameters
md5 Enter the md5 keyword to use the MD5 message-digest algorithm.
File Management 79