CLI Guide

multi-topology
Enables multi-topology IS-IS. It also allows enabling/disabling of old and new style TLVs for IP prex information in the LSPs.
Syntax
multi-topology [transition]
To return to a single topology conguration, use the no multi-topology [transition] command.
Defaults Disabled
Command Modes CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
net
To congure an IS-IS network entity title (NET) for a routing process, use this mandatory command. If you did not congure a NET, the IS-
IS process does not start.
Syntax
net network-entity-title
To remove a net, use the no net network-entity-title command.
Parameters
network-entity-title Specify the area address and system ID for an IS-IS routing process. The rst 1 to 13
bytes identify the area address. The next 6 bytes identify the system ID. The last 1 byte is
the selector byte, always identied as zero zero (00). This argument can be applied to an
address or a name.
Defaults Not congured.
Command Modes ROUTER ISIS
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
passive-interface
Suppress routing updates on an interface. This command stops the router from sending updates on that interface.
Syntax
passive-interface interface
To delete a passive interface conguration, use the no passive-interface interface command.
Intermediate System to Intermediate System (IS-IS) 785