CLI Guide

Parameters
peer-group-name (OPTIONAL) Enter the name of a peer group to view information about that peer group
only.
summary (OPTIONAL) Enter the keyword summary to view status information of the peers in that
peer group. The output is the same as that found in the show ip bgp ipv6
unicast summary
command.
Command Modes
EXEC
EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands
neighbor peer-group (assigning peers) — assigns a peer to a peer-group.
neighbor peer-group (creating group) — creates a peer group.
show ip bgp ipv6 unicast summary
Allows you to view the status of all BGP connections.
Syntax
show ip bgp ipv6 unicast summary
Command Modes
EXEC
EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show ip bgp ipv6 unicast summary command shown in the Example below.
Field Description
BGP router
identier
Displays the local router ID and the AS number.
BGP table version Displays the BGP table version and the main routing table version.
network entries Displays the number of network entries, route paths, and the amount of memory used to
process those entries.
BGP path attribute
entries
Displays the number of BGP path attributes and the amount of memory used to process
them.
IPv6 Border Gateway Protocol (IPv6 BGP) 745