CLI Guide

neighbor remove-private-as
Remove private AS numbers from the AS-PATH of outgoing updates.
Syntax
neighbor {ipv6-address | peer-group-name} remove-private-as
To return to the default, use the no neighbor {ipv6-address | peer-group-name} remove-
private-as command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation species successive hexadecimal elds of zeros.
peer-group-name Enter the name of the peer group to remove the private AS numbers.
Defaults Disabled (that is, the private AS number are not removed).
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
neighbor route-map
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
Syntax
neighbor {ipv6-address | peer-group-name} route-map map-name {in | out}
To remove the route map, use the no neighbor {ipv6-address | peer-group-name} route-map
map-name {in | out} command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation species successive hexadecimal elds of zeros.
peer-group-name Enter the name of the peer group.
map-name Enter the name of an established route map. If the Route map is not congured, the
default is deny (to drop all routes).
in Enter the keyword in to lter inbound routes.
out Enter the keyword out to lter outbound routes.
Defaults Not congured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
734 IPv6 Border Gateway Protocol (IPv6 BGP)