CLI Guide

peer-group-name Enter the name of the peer group.
maximum Enter a number as the maximum number of prexes allowed for this BGP router. The
range is from 1 to 4294967295.
threshold (OPTIONAL) Enter a number to be used as a percentage of the maximum value. When
the number of prexes reaches this percentage of the maximum value, the software
sends a message. The range is from 1 to 100 percent. The default is 75.
warning-only (OPTIONAL) Enter the keyword warning-only to set the router to send a log message
when the maximum value is reached. If this parameter is not set, the router stops peering
when the maximum number of prexes is reached.
Defaults threshold = 75
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
neighbor next-hop-self
Allows you to congure the router as the next hop for a BGP neighbor.
Syntax
neighbor {ipv6-address | peer-group-name} next-hop-self
To return to the default setting, use the no neighbor {ipv6-address | peer-group-name} next-
hop-self command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation species successive hexadecimal elds of zeros.
peer-group-name (OPTIONAL) Enter the name of the peer group.
Defaults Disabled.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If you congure the set ipv6 next-hop command in ROUTE-MAP mode, its conguration takes precedence
over the neighbor next-hop-self command.
IPv6 Border Gateway Protocol (IPv6 BGP) 733