CLI Guide

redistribute ospf
Redistribute OSPFv3 routes into BGP.
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match internal]]
[route-map map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf process-id command.
Parameters
process-id Enter the number of the OSPFv3 process. The range is from 1 to 65535.
match external {1 |
2}
(OPTIONAL) Enter the keywords match external to redistribute OSPF external
routes. You can specify 1 or 2 to redistribute those routes only.
match internal (OPTIONAL) Enter the keywords match internal to redistribute OSPFv3 internal
routes only.
route-map map-
name
(OPTIONAL) Enter the keywords route-map then the name of an established route
map.
If the route map is not congured, the default is deny (to drop all routes).
Defaults Not congured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information When you enter the redistribute ospf process-id command without any other parameters, the system
redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes.
router bgp
Enter ROUTER BGP mode to congure and enable BGP.
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
as-number Enter the AS number. The range is from 1 to 65535.
Defaults Not enabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch
708 IPv6 Border Gateway Protocol (IPv6 BGP)