CLI Guide

Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information In the system best path selection process, the path with the highest weight value is preferred.
NOTE: To apply the weight to the connection and recompute the best path, reset the neighbor
connection (the capture bgp-pdu max-buffer-size * command).
network
Specify the networks for the BGP process and enter them in the BGP routing table.
Syntax
network ipv6-address prefix-length [route-map map-name]
To remove a network, use the no network ip-address mask [route-map map-name] command.
Parameters
ipv6-address prex-
length
Enter the IPv6 address in the x:x:x:x::x format then the prex length in the /x format. The
range is from /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
mask Enter the mask of the IP address in the slash prex length format (for example, /24). The
mask appears in command outputs in dotted decimal format (A.B.C.D).
route-map map-
name
(OPTIONAL) Enter the keywords route-map then the name of an established route
map.
If the route map is not congured, the default is deny (to drop all routes).
Defaults Not congured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The software resolves the network address congured by the network command with the routes in the main
routing table to ensure that the networks are reachable using non-BGP routes and non-default routes.
Related Commands redistribute — redistributes routes into BGP.
IPv6 Border Gateway Protocol (IPv6 BGP) 705