CLI Guide

Usage Information The MED is a 4-byte unsigned integer value and the default behavior is to assume a missing MED as 4294967295.
This command causes a missing MED to be treated as 0. During path selection, paths with a lower MED are
preferred over those with a higher MED.
bgp client-to-client reection
Allows you to enable route reection between clients in a cluster.
Syntax
bgp client-to-client reflection
To disable client-to-client reection, use the no bgp client-to-client reflection command.
Defaults Enabled when a route reector is congured.
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Route reection to clients is not necessary if all client routers are fully meshed.
Related Commands
bgp cluster-id — assigns and ID to a BGP cluster with two or more route reectors.
neighbor route-reector-clientcongures a route reector and clients.
bgp cluster-id
Assign a cluster ID to a BGP cluster with more than one route reector.
Syntax
bgp cluster-id {ip-address | number}
To delete a cluster ID, use the no bgp cluster-id {ip-address | number} command.
Parameters
ip-address Enter an IP address as the route reector cluster ID.
number Enter a route reector cluster ID as a number from 1 to 4294967295.
Defaults Not congured.
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
IPv6 Border Gateway Protocol (IPv6 BGP) 667