CLI Guide

Field Description
Last Change Identies when the route was last changed or congured.
Example
Dell#show ipv6 route
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
Gateway of last resort is not set
Destination Dist/Metric, Gateway, Last Change
-----------------------------------------------------
C 100::/64 [0/0]
Direct, Te 0/8, 20:00:18
C 400::/64 [0/0]
Direct, Tu 1, 00:09:02
S 800::/64 [1/0]
via 100::1, Te 0/8, 00:00:50
L fe80::/10 [0/0]
Direct, Nu 0, 20:00:18
Dell#
Example (Summary)
Dell#show ipv6 route summary
Route Source Active Routes Non-active Routes
connected 3 0
static 1 0
Total 4 0
Total 4 active route(s) using 928 bytes
Dell#
trust ipv6-diserv
Allows the dynamic classication of IPv6 DSCP.
Syntax
trust ipv6-diffserv
To remove the denition, use the no trust ipv6-diffserv command.
Defaults none
Command Modes CONFIGURATION-POLICY-MAP-IN
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
When you congure trust IPv6 diserv, matched bytes/packets counters are not incremented in the show qos
statistics command.
Trust diserv (IPv4) can co-exist with trust ipv6-diserv in an Input Policy Map. Dynamic classication happens
based on the mapping as shown:
IPv6 Basics 661