CLI Guide
OSPFv3, in addition to the CoPP support for VRRP, BGP, and ICMP that existed in Dell Networking OS releases
9.3(0.0) and earlier
Related Commands show cong — views the current conguration.
ipv6 control-plane egress-lter
Enable egress Layer 3 ACL lookup for IPv6 CPU trac.
Syntax
ipv6 control-plane egress-filter
Defaults Not enabled.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
permit
To congure a lter that matches the lter criteria, select an IPv6 protocol number, ICMP, IPv6, TCP, or UDP.
Syntax
permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp} [count [byte]] [dscp
value] [order] [fragments] [log [interval minutes] [threshold-in-msgs [count]]
[monitor]
To remove this lter, you have two choices:
• Use the no seq sequence-number command syntax if you know the lter’s sequence number
•
Use the no permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp} command
Parameters
ip-protocol-number Enter an IPv6 protocol number. The range is from 0 to 255.
icmp Enter the keyword icmp to lter internet Control Message Protocol version 6.
ipv6 Enter the keyword ipv6 to lter any internet Protocol version 6.
tcp Enter the keyword tcp to lter the Transmission Control protocol.
udp Enter the keyword udp to lter the User Datagram Protocol.
count (OPTIONAL) Enter the keyword count to count packets the lter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the lter processes.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP values.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry. The
range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the keyword order, the ACLs have the
lowest order by default (255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
IPv6 Access Control Lists (IPv6 ACLs) 639