CLI Guide

ManualsBrandsDell ManualsAccess PlatformsFN IO Module

631

632

633

634

635

636

637

638

639

640

ipv4qos 1-10 l2qos

1-10

Command Modes CONFIGURATION

Supported Modes Full–Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

For the new settings to take eect, save the new CAM settings to the startup-cong (write-mem or copy run

start), then reload the system.

The total amount of space allowed is 16 FP blocks. System ow requires three blocks and these blocks cannot be

reallocated.

When conguring space for IPv6 ACLs, the total number of Blocks must equal 13.

Ranges for the CAM proles are from 1 to 10, except for the ipv6acl profile which is from 0 to 10. The

ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).

cam-acl-egress

Allocate space for IPv6 egress ACLs.

Syntax

cam-acl-egress {default | l2acl 1-4 ipv4acl 1-4 ipv6acl 0-4}

Parameters

default Use the default CAM prole settings, and set the CAM as follows:

• L2 ACL(l2acl): 1

• L3 ACL (ipv4acl: 1

• IPv6 L3 ACL (ipv6acl): 2

l2acl 1-4 ipv4acl 1- 4

ipv6acl 0-4

Allocate space to support IPv6 ACLs. Enter all of the proles and a range. Enter the CAM

prole name then the amount to be allotted. The total space allocated must equal 13. The

ipv6acl range must be a factor of 2.