CLI Guide

To delete a transform set, use the no crypto ipsec transform-set name {ah-authentication
{md5|sha1|null} | esp-authentication {md5|sha1|null} | esp-encryption {3des|
cbc|des|null}} command.
Parameters
name Enter the name for the transform set.
ah-authentication Enter the keywords ah-authentication then the transform type of operation to
apply to trac. The transform type represents the encryption or authentication applied to
trac.
md5 — Use Message Digest 5 (MD5) authentication.
sha1 — Use Secure Hash Algorithm 1 (SHA-1) authentication.
null — Causes an encryption policy congured for the area to not be inherited on the
interface.
esp-authentication Enter the keywords esp-authentication then the transform type of operation to
apply to trac. The transform type represents the encryption or authentication applied to
trac.
md5 — Use Message Digest 5 (MD5) authentication.
sha1 — Use Secure Hash Algorithm 1 (SHA-1) authentication.
null — Causes an encryption policy congured for the area to not be inherited on the
interface.
esp-encryption Enter the keywords esp-encryption then the transform type of operation to apply to
trac. The transform type represents the encryption or authentication applied to trac.
3des — Use 3DES encryption.
cbc — Use CDC encryption.
des — Use DES encryption.
null — Causes an encryption policy congured for the area to not be inherited on the
interface.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Both sides of the link must specify the same transform set.
You can create up to 64 transform sets.
Example
Dell(conf)#int ten 0/4
Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64
Dell(conf)#int ten 0/6
Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64
630 Internet Protocol Security (IPSec)