CLI Guide

management route
Congure a static route that points to the Management interface or a forwarding router.
Syntax
management route {ipv4-address | ipv6–address}/mask{forwarding-router-address |
managementethernet}
Parameters
{ipv4-address |
ipv6–address}/
mask
Enter an IPv4 address (A.B.C.D) or the IPv6 address followed by the prex-length for the
IP address of the management interface.
forwarding-router-
address
Enter an IPv4 address of a forwarding router.
managementethern
et
Enter the keyword managementethernet for the Management interface.
Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
Usage Information When a static route (or a protocol route) overlaps with Management static route, the static route (or a protocol
route) is preferred over the Management Static route. Also, Management static routes and the Management
Connected prex are not reected in the hardware routing tables. Separate routing tables are maintained for IPv4
management routes. This command manages both tables.
show arp
Displays the ARP table.
Syntax
show arp [interface interface ] [dynamic] [summary]
Parameters
interface interface (OPTIONAL) Enter the following keywords and slot/port or number information:
For the Management interface, enter the keyword managementethernet followed
by the slot/port information.
For a VLAN, enter the keyword vlan followed by a number from 1 to 4094.
dynamic (OPTIONAL) Enter the keyword dynamic to view dynamic entries.
summary (OPTIONAL) Enter the keyword summary to view a summary of ARP entries.
Command Modes EXEC Privilege
Supported Modes All Modes
IPv4 Routing 611